Scheuerlein christian (13 resultados)

Condición: New.

Condición: New. In English.

Taschenbuch. Condición: Neu. This item is printed on demand - it takes 3-4 days longer - Neuware -Diploma Thesis from the year 1997 in the subject Physics - Applied physics, grade: 1,0, University of Applied Sciences - Beuth (Verfahrens- und Umwelttechnik), language: English, abstract: Inhaltsangabe:Abstract:The influence of different air exposure times on the secondary electron emission of clean copper surfaces as well as on technical copper surfaces has been studied in the context of the phenomenon of multipacting, which can limit the performance of superconducting radio-frequency (RF) cavities for particle acceleration.The copper samples were prepared by heat treatments and in situ sputter-etching and they were investigated with a dedicated instrument for SEY measurements, by scanning electron microscopy (SEM), energy dispersive X-ray analysis (EDX), and by Auger electron spectroscopy (AES).After short air exposures of some seconds the maximum secondary electron yield dmax of clean copper is reduced from 1.3 to less than 1.2, due to the oxidation of the copper surface. Subsequent air exposure increases the secondary electron yield (SEY) until, after about 8 days exposure dmax is higher than 2.Clean copper samples were also exposed to the single gases present in air to find out the reasons for the dramatic increase of the SEY after long lasting air exposures. Only oxygen and water were found to affect secondary electron emission. An oxygen exposure decreases the SEY, while pure water exposure increases the SEY, but no single gas exposure changes dmax more than 0.2.Different methods have been tried in order to reduce the secondary electron yield of technical copper surfaces. For instance a 5 minutes air exposure of copper at 350 °C followed by a 350 °C bakeout reduces dmax to values close to unity.This procedure was applied to the outer, copper plated conductor of the LEP2 power couplers and its influence on pre-conditioning was tested. The results are promising but further tests are needed to confirm a beneficial effect of this treatment.Inhaltsverzeichnis:Table of Contents:Glossaryiv1.Introduction12.Basics32.1Secondary electron emission32.1.1The energy distribution of the emitted electrons32.1.2The secondary electron yield (SEY)42.1.3The SEY as a function of the primary electron energy42.1.4Influence of adsorbed layers of another species on the SEY52.1.5Influence of the work function on the SEY52.1.6Influence of the surface structure on the SEY52.2Air62.3Copper and copper oxidation72.4Vacuum basics92.4.1Kinetic theory of gases92.4.2The mean free path of a gas molecule92.4.3The monolayer time W92.4.4Gas flow regimes92.4.5Pumping speed S and throughput Q102.4.6Conductance C102.5Analytical techniques employed to characterise the sample surfaces112.5.1Scanning electron microscopy (SEM)112.5.2Energy dispersive X-ray analysis (EDX)112.5.3Auger electron spectroscopy (AES)123.The Experimental System133.1The electron gun153.2The vacuum system163.2.1The pumping system173.2.2Total pressure measurement203.2.3Partial pressure measurement234.Experimental Procedures254.1The cleaning of the samples254.1.1Bakeout254.1.2Glow discharge cleaning254.2Gas exposures284.2.1Air exposure284.2.2Pure water vapour exposure284.2.3Pure oxygen exposure294.3Error estimation315.Results325.1Influence of an air exposure on the SEY of initially clean copper325.2Influence of a pure oxygen exposure on the SEY of initially clean copper345.3Influence of a pure water vapour exposure on the SEY of initially clean copper355.4Influence of the other gases in air355.5Influence of a pure water vapour exposure on oxidised copper365.6Influence of a bakeout on the SEY365.7Influence o. 76 pp. Englisch. …

Condición: New. Print on Demand pp. 76 424:B&W 5.83 x 8.27 in or 210 x 148 mm (A5) Perfect Bound on Creme w/Matte Lam.

Condición: New. Print on Demand pp. 76.

PF. Condición: New. This item is printed on demand. Brand new book, sourced directly from publisher. Dispatch time is 6-7 days from our warehouse. Book will be sent in robust, secure packaging to ensure it reaches you securely.

PAP. Condición: New. New Book. Shipped from UK. THIS BOOK IS PRINTED ON DEMAND. Established seller since 2000.

PAP. Condición: New. New Book. Delivered from our UK warehouse in 4 to 14 business days. THIS BOOK IS PRINTED ON DEMAND. Established seller since 2000.

Condición: New. PRINT ON DEMAND pp. 76.

Taschenbuch. Condición: Neu. nach der Bestellung gedruckt Neuware - Printed after ordering - Diploma Thesis from the year 1997 in the subject Physics - Applied physics, grade: 1,0, University of Applied Sciences - Beuth (Verfahrens- und Umwelttechnik), language: English, abstract: Inhaltsangabe:Abstract:The influence of different air exposure times on the secondary electron emission of clean copper surfaces as well as on technical copper surfaces has been studied in the context of the phenomenon of multipacting, which can limit the performance of superconducting radio-frequency (RF) cavities for particle acceleration.The copper samples were prepared by heat treatments and in situ sputter-etching and they were investigated with a dedicated instrument for SEY measurements, by scanning electron microscopy (SEM), energy dispersive X-ray analysis (EDX), and by Auger electron spectroscopy (AES).After short air exposures of some seconds the maximum secondary electron yield dmax of clean copper is reduced from 1.3 to less than 1.2, due to the oxidation of the copper surface. Subsequent air exposure increases the secondary electron yield (SEY) until, after about 8 days exposure dmax is higher than 2.Clean copper samples were also exposed to the single gases present in air to find out the reasons for the dramatic increase of the SEY after long lasting air exposures. Only oxygen and water were found to affect secondary electron emission. An oxygen exposure decreases the SEY, while pure water exposure increases the SEY, but no single gas exposure changes dmax more than 0.2.Different methods have been tried in order to reduce the secondary electron yield of technical copper surfaces. For instance a 5 minutes air exposure of copper at 350 °C followed by a 350 °C bakeout reduces dmax to values close to unity.This procedure was applied to the outer, copper plated conductor of the LEP2 power couplers and its influence on pre-conditioning was tested. The results are promising but further tests are needed to confirm a beneficial effect of this treatment.Inhaltsverzeichnis:Table of Contents:Glossaryiv1.Introduction12.Basics32.1Secondary electron emission32.1.1The energy distribution of the emitted electrons32.1.2The secondary electron yield (SEY)42.1.3The SEY as a function of the primary electron energy42.1.4Influence of adsorbed layers of another species on the SEY52.1.5Influence of the work function on the SEY52.1.6Influence of the surface structure on the SEY52.2Air62.3Copper and copper oxidation72.4Vacuum basics92.4.1Kinetic theory of gases92.4.2The mean free path of a gas molecule92.4.3The monolayer time W92.4.4Gas flow regimes92.4.5Pumping speed S and throughput Q102.4.6Conductance C102.5Analytical techniques employed to characterise the sample surfaces112.5.1Scanning electron microscopy (SEM)112.5.2Energy dispersive X-ray analysis (EDX)112.5.3Auger electron spectroscopy (AES)123.The Experimental System133.1The electron gun153.2The vacuum system163.2.1The pumping system173.2.2Total pressure measurement203.2.3Partial pressure measurement234.Experimental Procedures254.1The cleaning of the samples254.1.1Bakeout254.1.2Glow discharge cleaning254.2Gas exposures284.2.1Air exposure284.2.2Pure water vapour exposure284.2.3Pure oxygen exposure294.3Error estimation315.Results325.1Influence of an air exposure on the SEY of initially clean copper325.2Influence of a pure oxygen exposure on the SEY of initially clean copper345.3Influence of a pure water vapour exposure on the SEY of initially clean copper355.4Influence of the other gases in air355.5Influence of a pure water vapour exposure on oxidised copper365.6Influence of a bakeout on the SEY365.7Influence o. …

Condición: New. Dieser Artikel ist ein Print on Demand Artikel und wird nach Ihrer Bestellung fuer Sie gedruckt. Diploma Thesis from the year 1997 in the subject Physics - Applied physics, grade: 1,0, University of Applied Sciences - Beuth (Verfahrens- und Umwelttechnik), language: English, abstract: Inhaltsangabe:Abstract:The influence of different air exposure. …

Taschenbuch. Condición: Neu. This item is printed on demand - Print on Demand Titel. Neuware -Inhaltsangabe:Abstract:The influence of different air exposure times on the secondary electron emission of clean copper surfaces as well as on technical copper surfaces has been studied in the context of the phenomenon of multipacting, which can limit the performance of superconducting radio-frequency (RF) cavities for particle acceleration.The copper samples were prepared by heat treatments and in situ sputter-etching and they were investigated with a dedicated instrument for SEY measurements, by scanning electron microscopy (SEM), energy dispersive X-ray analysis (EDX), and by Auger electron spectroscopy (AES).After short air exposures of some seconds the maximum secondary electron yield dmax of clean copper is reduced from 1.3 to less than 1.2, due to the oxidation of the copper surface. Subsequent air exposure increases the secondary electron yield (SEY) until, after about 8 days exposure dmax is higher than 2.Clean copper samples were also exposed to the single gases present in air to find out the reasons for the dramatic increase of the SEY after long lasting air exposures. Only oxygen and water were found to affect secondary electron emission. An oxygen exposure decreases the SEY, while pure water exposure increases the SEY, but no single gas exposure changes dmax more than 0.2.Different methods have been tried in order to reduce the secondary electron yield of technical copper surfaces. For instance a 5 minutes air exposure of copper at 350 °C followed by a 350 °C bakeout reduces dmax to values close to unity.This procedure was applied to the outer, copper plated conductor of the LEP2 power couplers and its influence on pre-conditioning was tested. The results are promising but further tests are needed to confirm a beneficial effect of this treatment.Inhaltsverzeichnis:Table of Contents:Glossaryiv1.Introduction12.Basics32.1Secondary electron emission32.1.1The energy distribution of the emitted electrons32.1.2The secondary electron yield (SEY)42.1.3The SEY as a function of the primary electron energy42.1.4Influence of adsorbed layers of another species on the SEY52.1.5Influence of the work function on the SEY52.1.6Influence of the surface structure on the SEY52.2Air62.3Copper and copper oxidation72.4Vacuum basics92.4.1Kinetic theory of gases92.4.2The mean free path of a gas molecule92.4.3The monolayer time W92.4.4Gas flow regimes92.4.5Pumping speed S and throughput Q102.4.6Conductance [¿]Diplomica Verlag, Hermannstal 119k, 22119 Hamburg 76 pp. Englisch.…

Taschenbuch. Condición: Neu. The Influence of an Air Exposure on the Secondary Electron Yield of Copper | Christian Scheuerlein | Taschenbuch | 76 S. | Englisch | 2002 | [.] | EAN 9783838654324 | Verantwortliche Person für die EU: Bedey und Thoms Media GmbH, Hermannstal 119k, 22119 Hamburg, kontakt[at]bedey-media[dot]de | Anbieter: preigu Print on Demand. …