Performance Based Building Design 1: From Below Grade Construction to Cavity Walls - Tapa blanda

Acerca de los autores

Prof. Em. Dr. Ir. Hugo S.L.C. Hens, University of Leuven (K.U. Leuven, Belgium), taught Building Physics from 1975 to 2003, Performance Based Building Design from 1970 to 2005 and Building Services from 1975 to 1977 and 1990 to 2008. Until 1972, he worked as a structural engineer at a mid-sized architectural company, constructing houses, apartment buildings and office buildings. He has authored and co-authored over 150 articles and conference papers, and written hundreds of reports on building damage cases and their solution. He has been coordinating the international working group CIB W40 on Heat and Mass Transfer in Buildings for ten years. Between 1986 and 2008, he was operating agent of four Annexes, initiated by the International Energy Agency's EXCO on Energy Conservation in Buildings and Community Systems: Annex 14, Annex 24, Annex 32 and Annex 41. He is also a fellow of the American Society of Heating, Refrigeration and Air Conditioning Engineers (ASHRAE).

Prof. em. Dr.-Ing. Hugo S. L. C. Hens, Universität Leuven (K.U. Leuven/Belgien) lehrte Bauphysik von 1975 bis 2003, Gebäudeplanung von 1970 bis 2005 und Technische Gebäudeausrüstung von 1975 bis 1977 sowie von 1990 bis 2008. Bis 1972 war er als Tragwerksplaner für Wohnhäuser, Büro- und Geschossbauten in einem Architekturbüro tätig. Er hat als Autor bzw. Koautor über 150 Artikel und Tagungsbeiträge veröffentlicht und hunderte Schadensgutachten erstellt. Während zehn Jahren koordinierte er die internationale Arbeitsgruppe CIB W40 "Heat and Mass Transfer in Buildings". Von 1986 bis 2008 war er im Rahmen des Forschungsprogramms "Energy Conservation in Buildings and Community Systems" der Internationalen Energieagentur IEA für die Erarbeitung von Annex 14, Annex 24, Annex 32 und Annex 41 verantwortlich. Er ist Mitglied der American Society of Heating, Refrigeration and Air Conditioning Engineers (ASHRAE).

De la contraportada

Just like building physics, performance based building design was hardly an issue before the energy crises of the 1970ies. With the need to upgrade energy efficiency, the interest in overall building performance grew. As the first of two volumes, this book applies the performance rationale, advanced in applied building physics, to the design and construction of buildings. After an overview of materials for thermal insulation, water proofing, air tightening and vapour tightening and a discussion on joints, building construction is analysed, starting with the excavations. Then foundations, below and on grade constructions, typical load bearing systems and floors pass the review to end with massive outer walls insulated at the inside and the outside and cavity walls. Most chapters build on a same scheme: overview, overall performance evaluation, design and construction.

This third book, after Building Physics and Applied Building Physics, is the result of 38 years of teaching architectural, building and civil engineers, coupled to more than 40 years of experience in research and consultancy. Where and when needed, input and literature from over the world was used, reason why each chapter ends listing references and literature.

The book should be usable by undergraduates and graduates in architectural and building engineering, though also building engineers, who want to refresh their knowledge, may benefit. The level of discussion assumes the reader has a sound knowledge of building physics, along wit a background in structural engineering, building materials and building construction.